Home > 1:35 Scale Moulds > 1:35 Scale Moulds for Walls

1:35 Scale Brick Wall Section (Stretcher Bond) Mould (1350067)

A 1:35 scale brick wall section mould with a new interlocking design allowing the construction of simple walls to relatively complex structures. Combine this mould with the new Brick Pier Section Mould for even more freedom of design.

The sections are easy to snap along the horizontal mortar joints (just score the back first) to adjust the wall section height. This mould also produces 2 off one and a half brick sections that could be used to adjust the wall sections length.

*Please note: wall sections produced with this mould will not interlock with the old 1:35 Scale Brick Wall Section Mould (1350029).

A few tips on using this mould:

Use the glass/plastic method to smooth off the plaster after filling the mould (see beginners guide on the tips & guides page).
Once removed from the mould, place a weight onto the large wall section until it has dried out to stop any distortion.
Run a small flat file around the smoothed off side of the cast wall sections to remove any flash before assembly (do this even if you cannot see any flash).
Use a water resistant/proof PVA type glue to assemble parts.
The sections are 3.25mm thick so will need a 0.5mm packer between sections when fitting them back to back to form one brick thick walls. We recommend 0.4mm ply as this is normally actually 0.5mm. See the Noville School Diorama walk through for more details.
When sticking wall sections back to back to form a one brick thick wall you can snap one section in half and place the bottom on top so that one whole brick will fit across the width of the wall. For taller walls (more than one section high) you only need to do this once as you can simply offset the wall sections (this will also strengthen the wall).
Wet the wall sections with water before filling the gaps between the bricks with mortar coloured Polyfilla (this is why it is advisable to use water resistant glue).
If you want to make the bricks look older, put some sand on a cutting mat and rub the cast wall section on it before sticking together.

Specifications:

Large brick wall sections per casting: 1
Approximate overall size of large section: L 85.75mm x H 60mm x W 3.25.
One and a half brick wall sections per casting: 2
Approximate size of one and a half brick wall sections: L 10.75mm x H 60mm x W 3.25.

We recommend:

Good quality hard castings plaster.
Powder pigments to colour the plaster.
The wall sections in the images were cast using Terracotta Casting Plaster with Iron. When filling the mould some black powder pigment was randomly mixed in.

SKU: 1350067